Which Side Of Iron On Vinyl Is The Liner

Then position it plastic side down and vinyl side up the more dull less shiny side.

Which side of iron on vinyl is the liner.

If you look carefully at iron on vinyl there is a liner side and a vinyl side. There is a layer of plastic that will be peeled away. If this isn t heat transfer vinyl then i would assume that the shiny side is the top side or the side that is going to be showing. The shiny side is the liner and the dull side is the heat activated side that you will.

Wool setting for 50 seconds on the front of the garment. It s the shinny side. Flip the base material over and apply medium pressure with the iron to the back of the material for an additional 25 30 seconds. You can see the vinyl side up in this photo of heat transfer vinyl on a standard grip cutting mat.

Iron on vinyl has a shiny side and a dull side. Iron on vinyl on the other hand has a shiny clear plastic carrier sheet on one side and the colorful matte back of the iron on vinyl on the other. Thus the dull side would be the liner side. There are many iron on vinyl suppliers out there.

Tips for using sportflex iron on face the bubbly side up. So again that s shiny side down. Use the iron to preheat your base material for 10 15 seconds place the weeded image shiny liner side up onto the preheated material apply medium pressure to each area of your design with the iron for 25 30 seconds. Iron over the back of the shirt or fabric for about 20 25 seconds.

Be sure to thoroughly pay attention to the size of the iron on vinyl sheet or roll that you are ordering. Using an iron. Place the iron on vinyl on the cricut standard grip cutting mat liner side down. 15 seconds on the back of the garment medium pressure.

You should not be able to peel back the iron on vinyl from the plastic sheet easily. Cut on iron on vinyl setting. Clearly the easy way to figure it out would be to try to pull the liner off from the vinyl and see which side has the sticky to it. Iron heat preheat the area of the material in which you will be applying your cut image for 5 10 seconds.

The liner side should be the one placed down on the mat. The iron on vinyl is put onto the roll carrier side out which means the side that curls down is the carrier side and the side that curls up is the vinyl side in the end if you re faced with two shiny sides the same color the slightly less shiny side is going to be the vinyl side.