Why Does My Brake Pedal Go To The Floor When I Start My Car

When you are ready to leave for work after your car has sat for a prolonged period of time check the ground underneath your car for puddles.

Why does my brake pedal go to the floor when i start my car.

When you push down on the brake pedal a little you re telling your car to slow down a bit. When you apply maximum force to the brake pedal you re telling your car you want to slow down very quickly. The most common reason this happens is because you have a leak in one of your lines. In case your car has a drum brake system after the above most common reasons for brake pedal goes to floor check your car s rear brake shoes.

If it s low top it off to the mark on the side of the reservoir. This article applies to the ford f 150 2004 2014 and f 250 super duty 2005 2014. I bled the brakes and the master cylinder at least 10 times. So i ruled out the master cylinder since i just replaced it last week.

The brake pedal is what you use to communicate to the car that you want it to slow down and it should always function the same. The brake system in your car is a sealed hydraulic system and relies on close tolerances between the brake pads and rotors or the brake shoes and drums. If your brake pedal sinks towards the floor when you are stopped while your foot is on the brake or does not feel as firm when the brakes are applied this could indicate you are having some sort of trouble with. The booster is a mechanism that uses vacuum pressure to take the force being applied to the brake pedal and amplify it.

A brake pedal that feels mushy spongy or that slowly sinks to the floor when depressed can be best described as brake pedal sink. If you hit your ford f 150 or super duty s brake pedal and it goes to the floor stop the vehicle and don t drive it until you find a solution to this problem. If you step on the brake pedal and it feels like it s going too far down before you start to slow you might have the following problems. Low brake fluid level.

If the booster is bad then the full amount of force needed to activate the master cylinder and pressurize the brake fluid isn t going to be there. Also if a leak occurs in the system it will be unable to build pressure due to the lack of fluid causing the brake peddle to travel to the floor which can be followed by the brake system. Check your brake fluid. The pedal will go all the way to the floor and the car will be harder to stop.

Brake pedal too low or goes too far down before slowing.