Why My Carpet Cleaner Machine Does Not Spraying

One is for the solution and the other is where the dirty water flows back into.

Why my carpet cleaner machine does not spraying.

I have a fairly new hoover rug cleaning machine with two containers. On the hand held washer mainly used for upholstery the problem of not spraying water can be overcome by removing the pin from the blue trigger assembly to expose the black push button valve start up the machine and depress the button with a pencil if the water starts to come out the problem lies with the height of the button there are two ways. Remove the red solution filter cap on the base of the machine by using a coin or screwdriver and turning the cap counterclockwise. To check turn off machine and hold the spray trigger for 30 seconds.

To fix this you need to turn the cleaner on and lower the hose down to the floor. The company offers a variety of carpet cleaners that remove stains from carpet using a combination of water and cleaning solution. The bissell company produces a variety of machines designed to clean hard floors and carpet. If no water was released from valve remove the clean and dirty water tanks from machine lay machine on its side and recline the brush roll by pressing the latch clean the spray tip with an old toothbrush or any other soft bristle brush.

After extended use it is possible for the carpet cleaner to malfunction by not dispensing water. Remove the tank and set it aside. Your solution filter could be clogged to check turn off your unit and unplug from the wall. Depending on which model of carpet cleaner you have you may need to move the handle of the tank back or down to lock it in place.

Stand the machine upright and replace the water tank. The tank should fit snugly into place and not wiggle or wobble on the bissell carpet cleaner. My hoover carpet shampooer is not spraying water but dripping it. Make sure that the water tank is full.

Lay down the carpet cleaner backward and look at the bottom of the. The bissel carpet cleaner has been a frequent visitor to old sneelock s workshop. Every time before the use of your bissell carpet cleaner fill the tank with clean water from the filled line. Turn machine back on and check for spray.

Next prime the pump by holding down the trigger for up to 1 minute. If the cleaner is still not spraying despite the water and detergent tanks being full there may be a bubble of air stuck in the pump or the hose. Does anyone know how to fix the water cleaner sprayer.